Application for various tree works including creating woodpecker holes, ringbarking, and coronet cuts on Oak and Beech trees.

Full Proposal

V1- Oak Woodpecker holes x 3. 50cm apart starting at fork and rising up the S leaning stem on the southern aspect V2- Beech Ringbark limb x1. Ring bark first live limb 20cm from stem. Woodpecker hole x1. Create woodpecker hole where existing branch stub is at approx. 8m. Remove leader. Remove leader to lateral growth point at 9.5m V3- Beech Coronet cuts. Remove at crown break and add coronet cuts. Woodpecker hole x 2 . Add one woodpecker hole on each of the twin stems V4- Beech Coronet cuts. Remove crown leaving each of the 3 stems at different heights. North stem just above where it splits, approx. 14m. Middle stem 1m past union. Southern stem 2m higher than N stem. Add coronet cuts to each cut. Woodpecker hole x1. Add one woodpecker hole above 4m. Lateral split x1 Add one lateral split at 1m in length V5- Oak Woodpecker holes x3. Create 3 woodpecker holes 50cm apart starting at fork and rising up the south leaning stem on the southern aspect. V6- Oak . Ringbark leader. Ring bark leader which is leaning over field 30cm past fork . Woodpecker hole x1. Create one woodpecker hole on southern aspect of stem 30cm below fork SEE ATTACHED SPECIFICATION FOR FURTHER CONTEXT

Application Timeline

Application Registered

N/A

Application Validated

16/09/2025

Target Decision Date

11/11/2025

Committee Date

N/A

Decision Made

07/11/2025

Decision Issued

07/11/2025